Kast peaks GV 2002 korral sama olema kui vanematel mudelitel ehk 41TE. Kasti juhendist suurt midagi abi pole.
Vast on abi sellest infost:
Kood:
DTC P0604, P0605, P0700: INTERNAL TRANS CONTROLLER
Possible Causes
Internal TCM failure.
Diagnostic Procedure
Using scan tool, check Global Good Trip (GGT) counter. If GGT counter displays 3 trips or less, replace TCM. If GGT counter displays more than 3 trips, go to next step.
Record all DTCs and one trip failures. Using scan tool, erase DTCs. See CLEARING DIAGNOSTIC TROUBLE CODES . Turn ignition from off to on, then start engine. Apply brakes. Slowly move shift lever through each gear position. Check if DTC P0604, P0605 and/or P0700 has reset. If DTC P0604, P0605 and/or P0700 is present, replace TCM. If DTC P0604, P0605 and/or P0700 is not present, go to next step.
Inspect the following for pushed out terminals or faulty connections and repair as necessary:
Engine Ground Connections
TCM Grounds
TCM Battery Feed
TCM Fused Ignition Switch Output Circuit
Power Feed To Transmission Control Relay
If procedure in previous step fails to diagnose problem, erase DTCs using scan tool. Set GTC counter to zero. Perform VER-1A: VERIFICATION TEST . If transaxle is still not functioning correctly, go to next step. If transaxle is functioning correctly, test is complete.
NOTE:Low battery voltage can be a source of many non-DTC symptoms.
Inspect battery voltage. Ensure battery is fully charged. Correct as needed. Perform VER-1A: VERIFICATION TEST . If battery voltage is okay, see TROUBLE SHOOTING in CHRYSLER 41TE/AE & MITSUBISHI F4AC1 OVERHAUL article.